Updated October 2026
Short answer: new seamless aluminum gutters in the Knoxville area typically cost about $8–$13 per foot for 5-inch and $10–$16 per foot for 6-inch, installed. A full two-story home usually lands between $1,800 and $3,500 with downspouts. Adding micro-mesh guards adds roughly $12–$30 per foot.
These are typical installed ranges for the Knoxville area in 2026, meant for planning and comparing quotes. Your price depends on the specifics of your house, which is why every estimate is done on site.
Price per foot
| Item | Typical installed range | Notes |
|---|---|---|
| 5" seamless aluminum (K-style) | $8–$13 / ft | Most common on single-story and smaller homes |
| 6" seamless aluminum (K-style) | $10–$16 / ft | Large or steep roofs, metal roofs |
| Half-round aluminum | $14–$24 / ft | Older and historic homes |
| Copper | $30–$50+ / ft | Specialty; price follows copper markets |
| Downspouts (2x3 or 3x4) | $90–$250 each | Depends on length and story height |
| Micro-mesh gutter guards | $12–$30 / ft | Cheaper when installed with new gutters |
| Perforated aluminum guards | $7–$14 / ft | Good for big leaves, not pine needles |
| Old gutter removal | $1–$2 / ft | Often included |
| Fascia board replacement | $10–$25 / ft | Only where rotted |
| Buried downspout drain line | $300–$900 each | Depends on run length and terrain |
Three typical jobs
Single-story ranch, Halls or Alcoa
About 140 feet of 5-inch gutter, 5 downspouts, no fascia issues: roughly $1,400–$2,200.
Two-story home, Farragut or Hardin Valley
About 200 feet of 6-inch gutter, 7 downspouts in 3x4: roughly $2,400–$3,800. Add micro-mesh guards and it's roughly another $2,400–$5,000.
Mountain cabin, Wears Valley
About 160 feet of 6-inch .032 gutter under a metal roof, tight hanger spacing, difficult access, micro-mesh guards: roughly $4,500–$8,000, mainly driven by access and guards.
What pushes the price up
- Story height and access: a third-story run over a deck takes more time and equipment than a ranch.
- Roof complexity: every inside and outside corner is cut, mitered and sealed.
- Rotted fascia: found at the estimate and priced separately.
- Gauge and size: 6-inch .032 costs more than 5-inch .027, and is worth it on big or metal roofs.
- Guards: often double the total. Worth it under heavy trees, not always otherwise.
Why you'll see different numbers online
National averages mix together partial repairs, small homes and full replacements. Full-home seamless replacement on a typical two-story home usually runs higher, as above.
Gutter-guard pricing varies the most. Some national guard companies quote well above the ranges here after a long in-home sales visit. Always get a per-foot price in writing so you can compare.
How to compare quotes
- Is it seamless, and what size and gauge?
- Hanger type and spacing?
- How many downspouts, and what size?
- Is fascia replacement included or extra, and at what rate?
- Is removal and haul-off included?
- What warranty comes with the workmanship?
Common questions
How much do gutters cost for a 2,000 sq ft house in Knoxville?
A 2,000 square foot two-story home typically needs 150–200 feet of gutter. With seamless aluminum and downspouts, expect roughly $1,800–$3,200, more with guards or fascia repair.
Are 6-inch gutters worth the extra cost?
On large, steep or metal roofs, yes. The extra cost is usually 15–25% and the gutters handle much heavier rain.
Is it cheaper to add gutter guards later?
No. Guards cost less to install at the same time as new gutters, since the crew and equipment are already there.